Tiller steer, for threaded fork (Nazca)

Tiller steerer for 1 1/8" or 1" thread type front fork, stainless steel steerer tube with aluminium hinge part. Cables run inside the steerer tube. The steerer is adjustable in length and inclination angle. Heat shrink tubing included.

Two lengths available: 370-435 mm and 350-405 mm, make a choice (compulsory)

Available for 1 inch (internal fork tube diameter 22.2 mm) and 1 1/8" (internal diameter fork tube 25.4 mm) forks.

Note: Handlebars not included.

Guiding cables through a tiller steerer.

- make a bundle of the cables, tie them together with tape, leaving one cable approx. 3 cm longer
- estimate the position of the heat-shrink tubing and put it in place (plus heat it to shrink)
- carefully guide the cables inside the tiller opening (start at the bottom side), until you can pick-up the outstanding cable
- try to bundle cables as much as possible with tie-wraps, this prevents you from getting caught up in it